Hello Martyn,
The problem I am seeing is that the original prompt is:
[2.1.5-RELEASE][cattools@firewall.local]/home/cattools(1):
It then changes to the following after it receives the configuration information:
[2.1.5-release][cattools@firewall.local]/home/cattools(2):
As CatTools is looking for "[2.1.5-RELEASE][cattools@firewall.local]/home/cattools(1" to ensure that the command completed and it does not see it, it assumes the command failed at some point.
In order to fix this, open the Variations for the Device, go to the "Full Prompts" tab and set the Enable Prompt to "firewall.local]/home/cattools". This way, every time CatTools sees "firewall.local]/home/cattools", it will assume that it is at an Enable prompt.
Hopefully this helps.
Sincerely,
Chris Foley (a.k.a. Fodome)